38
© 2008 Directed Electronics. All rights reserved.
Step Function
1
Auto Learn Standard Configuration (default)
The auto learn configuration will automatically setup the remote
button configuration. Note: Due to the Supercode protocol, you
cannot change the configuration.
2
Delete remotes: This feature will erase all remotes from the memory
of the system. This is useful in cases when a customer’s remote is
lost or stolen. Note: Does not reset the programmed features of the
system or reset the Virtual Tach setting.
3
Reset Features: This resets all the features of the system to the fac-
tory default settings. Note: Does not delete the remotes from the
system or reset the Virtual Tach setting.
4
Virtual Tach Reset: Deletes all previously learned values for Virtual
Tach, and on the next remote start sequence the unit will begin
virtual tach initialization. Note: The “Zap” feature on the Bitwriter
does not reset the Virtual tach setting.
3.Transmit. Press the button on the remote control.
The horn honks to confirm that the code has been suc-
cessfully programmed. It is not possible to teach a
remote control button to the system more than once.
4. Advance. You can advance from one function step to
another by releasing the Valet/Program switch and tap-
ping it to advance function steps and then holding it.
Learn Routine is exited if:
The ignition is turned off•
The program switch is pressed too many times•
More than 30 seconds elapses between steps•
To Next Page
Loading...
Need help?
General
