46
© 2008 Directed Electronics. All rights reserved.
Feature descriptions
The features of the system are described below. Features that have additional
settings that can be selected only when programming with the Bitwriter® are
indicated by the following icon:
Important:
Default settings are in bold. The numbers in pa-
rentheses indicate the number of times the LED on the control
center flashes.
➤ Menu 1 - Keyless entry
1-1 Active/Passive Locking/Auto-relocking:
When active locking (1) is select-
ed, the system only locks when the transmitter is used. When set to passive (2)
the system automatically locks 30-seconds after the last door is closed. To alert
the consumer of passive locking, the horn honks 20-seconds after the door is
closed. This provides the consumer with an audible warning prior to the system
actually locking. At the 30-second mark the system locks, but without the horn
honk.
When Auto re-locking (3) is On, the system re-locks the doors 30 seconds after
the system is unlocked when using the remote, and the doors on the vehicle
have not been opened. If a door is opened when the re-lock timer is active, the
auto re-lock feature is defeated until the system sees another unlock command
from the remote.
Important:
The optional door input must be connected for
this feature to work.
1-2 Panic On:
(1 LED flash) This feature controls whether or not the panic mode
is available with the ignition on. In some states there are laws prohibiting a
horn continually sounding in a moving vehicle. This feature makes the system
compliant with these regulations. The LED flashes twice (2) to indicate Panic with
ignition Off. When Panic is Off, the LED flashes (3)
To Next Page
Loading...
Need help?
General
