59
© 2008 Directed Electronics. All rights reserved.
Troubleshooting
➤ Keyless entry system
System will not passively lock until it is remotely locked and then un-•
locked:
Are the door inputs connected? Is the H1/6 blue wire connected to the door
trigger wire in the vehicle? Either the H1/5 green or the H1/7 violet should be
used instead. (See wiring diagrams.)
The Valet/Program switch doesn’t work.•
Is it plugged into the correct socket? See Plug-In LED and Valet/Program Switch
section of this guide.
Status LED doesn’t work.•
Is it plugged in? (See Plug-In LED and Valet/Program Switch section of this
guide.) Is the LED plugged into the correct socket?
Door locks operate backwards. •
This unit has easily-reversed lock/unlock outputs. Recheck wire connections to
see if you have reversed these.
➤ Remote start
The remote start will not activate•
Check remote startup diagnostics to determine what may be the cause of 1.
the no start situation.
Check the harnesses and their connections. Make sure that the harnesses 2.
are completely plugged into the remote start module. Make sure there are
good connections to the vehicle wiring.
Check voltage and fuses on the main 12-pin harness and on the heavy 3.
gauge remote start harness.
To Next Page
Loading...
Need help?
General
