EasyManuals Logo

Directed Electronics Python 1401 Installation Guide

Directed Electronics Python 1401
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #61 background imageLoading...
Page #61 background image
The vehicle starts, but will only run for 10 seconds.•
Is the remote start programmed for voltage sense? If this does not work, a 1.
tach wire should be used.
Check shutdown diagnostics.2.
The climate control system does not work while the unit is operating the •
vehicle.
Either the wrong accessory wire is being energized or more than one igni-
tion or accessory wire must be energized in order to operate the climate
control system.
Manual Transmission Start diagnostics•
When enabling MTS, if you get a failure notification from the remote or
the vehicle fails to remain started when you shut off the key, check for
following:
Hood Open (gray wire)•
Foot Brake active (brown wire)•
No Parking Brake input-Black/white neutral safety wire not showing •
ground with parking brake set.
Tach not hooked up or programmed•
Toggle switch not installed or not in the ON position. •

Table of Contents

Other manuals for Directed Electronics Python 1401

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Directed Electronics Python 1401 and is the answer not in the manual?

Directed Electronics Python 1401 Specifications

General IconGeneral
BrandDirected Electronics
ModelPython 1401
CategoryRemote Starter
LanguageEnglish

Related product manuals