Directed 5906 - Menu 3: Remote Start Features

21
© 2016 Directed. All rights reserved.
Menu 3 - Remote start
Item Feature
Opt. 1
Opt. 2 Opt. 3 Opt.4 Opt. 5+
1 Transmission Mode
Manual
Automatic
2 Engine Checking Mode
Virtual Tach
Voltage OFF Tachometer
3 Cranking Time (seconds)
0.6 sec.
0.8 sec. 1.0 sec. 1.2 sec. 1.4 (5)/ 1.6
(6)/ 1.8 (7) 2.0
(8)/ 4.0 (9)
4 Remote Start Runtime (minutes)
12 min.
24 min. 60 min.
5 Activation Pulse Count
1
2
6 Turbo Mode (minutes)
No Turbo Mode
On-1 min. On-3 min. On-5 min. On- 10 min.
7 Timer Mode Runtime (minutes)
12 min.
3 min. 6 min. 9 min.
8 Flex Relay Function
Ignition 2
Accessory 2 Starter 2
9 Diesel Start Delay (seconds)
Wait-to Start
input
Timed 15 sec. Timed 30 sec. Timed 45 sec.
10 Accessory during Diesel Start Delay
ON
OFF
11 Status 2 Output
Status
Latch Rear
Defogger
Pulse Rear
Defogger
12 Parking Light Output
Constant
Pulsed OFF
13 Anti-grind Output
ON
OFF
14 Tach Mode Starter Release
Normal
Increase Decrease
15 Vehicle Temp Auto Report *
OFF
On
16 Remote Start Safelock
OFF
On
* Not available with the 1-way remote control.
1. Transmission Mode
1. Manual: requires ‘Tachometer’ for the Engine Checking Mode, and requires the user to successfully
perform a procedure when parking the vehicle before remote starter will engage.
2. Automatic: uses any of the Engine Checking Modes and does not require any special procedures
when parking.
2. Engine Checking Mode
1. Virtual Tach: battery voltage drop/rise during cranking determines when the starter output is
released. During runtime, constant voltage level is monitored to determine if the engine is running.
2. Voltage: starter output during cranking is a programmed duration (Set in Cranking Time). During
runtime, constant voltage level is monitored to determine if the engine is running.
3. OFF: starter output during cranking is a programmed duration (Set in Cranking Time). The remote
start will keep the ignition/accessories active for the programmed runtime whether the engine is
running or not.
4. Tachometer: tachometer input signal during cranking and runtime to determine when the starter
output is released and if the engine is running.
3. Cranking Time
• 0.6/0.8/1.0/1.2/1.4/1.6/1.8/2.0/4.0 seconds: determines the starter output duration during
cranking for the ‘Voltage’ and the ‘OFF’ Engine Checking Mode options.
4. Remote Start Runtime
• 12/24/60 minutes: sets engine runtime during normal remote start operations.
5. Activation Pulse Count
• 1/ 2 pulses: sets the number of remote control commands received or Activation Input required to
activate and de-activate remote start.