Directed 5906 - Bitwriter - Only Options; Starter Release Fine Tune; Feature Programming Locks; Remote Start Runtime Configuration

24
© 2016 Directed. All rights reserved.
Bitwriter - Only Options
If programming with the Bitwriter or XKLoader 3, the Learn Routine can be locked or unlocked. If the
Learn Routine has previously been locked, it must be unlocked with Bitwriter - this cannot be done
manually with the Control Center button.
The Bitwriter
gives you access to a wider range of system options. These features and the adjustments that
may be programmed are described in the table below.
Item Feature
Default
Opt. 2 Opt. 3 Opt.4 Opt. 5+
1 Zone 4 Sensor Type*
None
Shock/
Omni
Field
Disturbance
Tilt Sensor Glass Break (5)/Ultrasonic (6)
2 Siren Duration (seconds)
30 sec.
Options: 1 to 180 sec.
3 AUX/Trunk Icon Type*
Trunk
Window Sunroof Audio Lights/Left dr/Right dr/Rear
Hatch
4 AUX 1 Timed Output (seconds)
30 sec.
Options: 1 to 90 sec.
5 AUX 1 Remote Icon Type*
Pulsed
Trunk Window Sunroof Audio/Lights/Left dr/Right dr/
Rear Hatch/Timed/Latched
6 AUX 2 Timed Output (seconds)
30 sec.
Options: 1 to 90 sec.
7 AUX 2 Remote Icon Type*
Pulsed
Trunk Window Sunroof Audio/Lights/Left dr/Right dr/
Rear Hatch/Timed/Latched
8 AUX 3 Timed Output (seconds)
30 sec.
Options: 1 to 90 sec.
9 AUX 3 Remote Icon Type*
Pulsed
Trunk Window Sunroof Audio/Lights/Left dr/Right dr/
Rear Hatch/Timed/Latched
10 AUX 4 Timed Output (seconds)
30 sec.
Options: 1 to 90 sec.
11 Diesel Start Delay Timer (seconds)
15 sec.
Options: 1 to 90 sec.
12 Timer Mode Runtime (minutes)
12 min.
Options: 1 to 16 min.
13 Timer Mode Starts
6 starts Options: 1/2/3/4 to 24 (Starts) in increments of 2
14 Timer mode intervals (hours)
3 hr.
Options: 1/2/3/4 to 24 in 2 hour increments
15
Smart start low temp (Fahrenheit)
0° (F)
Options: OFF, -20° to 70° in 10° increments
16
Smart start high temp (Fahrenheit)
100° (F)
Options: OFF, 40° to 130° in 10° increments
17
Smart start low battery (volts)
10.5V
Options: OFF, 9V to 12.5V in 0.5V increments
18 N/A
N/A
N/A
19
Starter Release Fine Tune
6
(normal)
Options: 0 to 20 in increments of 1
20
Feature Programming
Unlocked
Locked
21
Transmitter Programming
Unlocked
Locked
22
Remote Start Runtime (minutes)
12 min.
Options: 1 to 60 min.
23
Virtual Tach Fine tune
(milliseconds)
Not
Initialized
Options: Not initialized, 0 to 1000 in 50 millisecond increments
* Feature only available for the LCD 2-way remote control with display screens.
Note: The Bitwriter is a hand held Feature Programming tool that can be used to fine tune and access certain
features that are not accessible with manual programming. The Bitwriter plugs into the black 3-pin plug on the
system. The black 3-pin port will also be utilized by the optional Smartstart module when applicable.