P.10 User Guide
5. Exit the vehicle. All doors should be closed, including the hood and trunk.
6. THERE ARE THREE POSSIBLE OPTIONS TO COMPLETE READY MODE
(programmable by installer)
OPTION 1:
Automatic shutdown
without auto lock
OPTION 2:
Manual shutdown
(default)
OPTION 3:
Automatic shutdown
with auto lock
The engine runs for
8 sec. before finally
shutting down the
engine, without user
interaction.
The engine keeps going
until you press either;
a. to lock the doors and
shut down the engine;
b. to unlock the doors
and shut down the
engine;
c. to shut down the
engine without affecting
the doors.
The engine runs for
8 sec. then locks the
doors before finally
shutting down the
engine, without user
interaction.
WARNING: The
vehicle is not armed or
locked down.
WARNING: Engine runs
until the pre-programmed
run time expires.
WARNING: Do not
leave your keys in the
vehicle!
7. The Parking lights will flash twice to indicate Ready mode is set.
Remote-starting
Press the button for approximately 1 second. The parking lights will
turn ON to inform you that the Remote Car Starter has received your signal.
Approximately 5 seconds later, the engine will start. The parking lights will remain
ON during the pre-programmed run time of the engine.
If your vehicle does not start at the first attempt, the system will shut down, wait a
few seconds and try to start the engine again. There will be 3 start attempts
before the system gives up.
Driving Off
With the vehicle running remotely, press the button to disarm the
starter kill (if installed) and unlock the doors. Enter the vehicle and do the
following:
To Next Page
Loading...
Need help?
General
