User Guide P.21
Note: Pressing the AUX button 2x quickly causes the LED to flash slowly and to
shift to level 1 (AUX 2, configurable by your installer). Pressing the AUX button
3x quickly causes the LED to flash fast and to shift to level 2 (second car
operation).
AUX 2
If configured at installation, this feature can be activated by pressing the 2x on
the AUX button (or “Shift level 1”) followed by pressing the button while
the LED is slowly flashing.
OEM-Style Alarm
The OEM-style alarm (if configured by your installer) monitors the doors, hood
and ignition switch of your vehicle. It will sound the horn if a door or the hood is
opened, or if the key is turned in the ignition.
To arm the OEM-style alarm, press the button on the
transmitter.
The OEM-style alarm will ONLY arm if the button on the
transmitter is pressed.
-The LED on the antenna will flash slowly to indicate that the OEM-style
alarm is now armed.
To disarm the OEM-style alarm, press the button on the
transmitter.
To stop the horn from sounding if the OEM-style alarm is triggered,
press the or button, or put the system in and out of
Valet Mode (page 13)
Intrusion Codes via horn
The system monitors the following:
Doors
Hood
Ignition
Note: If an intrusion has occurred the HORN will sound for a maximum of
1 minute.
To Next Page
Loading...
Need help?
General
