CHAPTER 3: Installation
3. Change IP address setting to manual if set to DHCP and enter:
- IP address: 10.0.0.20
- subnet mask: 255.255.255.0
4. Open an internet browser (e.g. Chrome, Firefox) and enter http://10.0.0.24
to open the GUI of the controller. The online wizard will open automatically
and guide you through all necessary steps.
NOTE!
Following you may want to restore the network settings of your computer to the
original values.
5. After setup log in and check the firmware version (go to ‘Misc -Version-
System Information’). If a newer firmware is available, go to ‘Configuration-
Device-Firmware Update’ and perform a firmware update.
The latest version of the firmware is available on the M.1K2 product page at
www.directout.eu.
To Next Page
Loading...