DirecTV C61W User Manual

Version 1.0.0 12/16/2016
•
If the user selects Setup Instructions the instructions screen is displayed.
4) Select
the placement for the WVB
Select a location for the WVB
•
Best location to provide GREE
(use 5 walls and 80 feet as the guide)
•
Access to the coax SWiM network. Do not connect the W
network yet.
5) Power
on the WVB
up to a state referred to as ‘Survey mode’ or
transmits a signal for
sequence is as follows:
• WVB2
LED
•
The boot up takes approximately two minutes.
•
Once boot up has completed, the WVB
• The WVB
2
Wireless Video Bridge S
that have not previously been paired (factory
reset to factory defaults.
6)
The signal strength on every wireless client (
checked by ensuring that the Network LED
User Manual –
Wireless Video Bridge Gen 2
Page 18
If the user selects Setup Instructions the instructions screen is displayed.
FIGURE 6: C41W SIGNAL STRENGTH SCREEN
the placement for the WVB
2
Select a location for the WVB
2
based on the following factors:
Best location to provide GREE
N LED to all wireless clients(
(use 5 walls and 80 feet as the guide)
Access to the coax SWiM network. Do not connect the W
network yet.
on the WVB
2
and observe the power up sequence.
up to a state referred to as ‘Survey mode’ or
‘
Beacon
transmits a signal for
wireless clients (C41W, C6
1W)
sequence is as follows:
LED
flashes BLUE during boot up.
The boot up takes approximately two minutes.
Once boot up has completed, the WVB
2
LED alternates GREEN/YELLOW.
2
is now in Video Bridge Survey/Beacon
mode.
Wireless Video Bridge S
urvey/Beacon
mode works only on WVB
that have not previously been paired (factory
fresh
) or client
reset to factory defaults.
The signal strength on every wireless client (
C41W,
C
checked by ensuring that the Network LED
is GREEN
Wireless Video Bridge Gen 2
If the user selects Setup Instructions the instructions screen is displayed.
based on the following factors:
N LED to all wireless clients(
C41W, C61Ws)
Access to the coax SWiM network. Do not connect the W
VB2 to the coax
and observe the power up sequence.
The WVB boots
Beacon
Mode’ where it
1W)
. The WVB boot
LED alternates GREEN/YELLOW.
mode.
mode works only on WVB
2 and clients
) or client
s that have been
C
61W) should be
is GREEN

DirecTV C61W Specifications

General

Brand	DirecTV
Model	C61W
Category	Receiver
Language	English