Page 14
Chapter 2
Parts of the System
S
CAN FOR DEVICE CODES
If the code for your device is not listed in the tables starting on page 68, use this
procedure to scan the remote control’s memory for the device code.
6. If you want to program
Limited Mode, press 1. If not
skip to step 7.
See Limited Mode on page 12 for
more information.
7. Press the POUND (#) button.
If you are programming a TV/
VCR or TV/DVD
combination, repeat step 3
with the remote control in
DVD mode.
If you entered the code correctly, the
mode button flashes three times.
8. Press the POWER button to
turn off the device. If the
device does not turn off, go to
step 10.
If the code works, the device should
turn off.
9. Turn the device back on and
try some other buttons to
make sure they work. If the
code works for other buttons,
stop here.
Sometimes the POWER button
works when other buttons don’t.
10. If the code doesn’t work,
repeat steps 3 through 8 with
another device code from the
tables.
Try every code listed for your brand
until one works for your device.
11. If you can’t find a code that
works, try Scan for Device
Codes below.
1. Turn the device on. Use the device’s front panel buttons
or its remote control.
2. Press and hold the mode
button until all the other mode
buttons light up, and then
release the button.
The mode button flashes.
For example, hold the TV mode
button for a TV until all of the other
mode buttons light. When you
release, the TV mode light flashes.
3. For AUX mode only. Press 0
for a second TV, or 1 for a
VCR or DVD player, or 2 for
a tuner, or amplifier. Press the
STAR (*) button.
This step is for programming which
kind of device that should be
programmed in AUX mode. If
you’re not programming in AUX
mode, skip to step 4.
To Next Page
Loading...
