Page 16
Chapter 2
Parts of the System
P
ROGRAM THE REMOTE TO CONTROL A SECOND RECEIVER IN AUX
M
ODE
If you have another DISH receiver installed, you can use this remote control in
AUX mode to operate your second receiver. AUX mode uses only IR signals, so
the line of sight from the remote to the second receiver must be unobstructed.
You can program the remote control to operate any other DISH receiver except
where UHF is used, such as TV2 on DISH receivers.
1. Turn on the second receiver and open the
System Info screen.
2. Write down the TV1 address that is shown. ________________
3. Press and hold AUX until all the Mode buttons light up, then release
AUX. The AUX mode button flashes.
4. Use the Number Pad on the remote control to enter a 3, followed by
the address in step 2.
5. Press POUND (#). AUX flashes three times.
6. Press RECORD to verify that the address in the remote control
now matches the address for the receiver.
CONTROL A TUNER OR AMPLIFIER
AUX MODE BUTTON
To use the remote to operate a tuner or amplifier, first set up the remote
to control the device, then press the AUX mode button to set the remote
to AUX mode. The AUX mode button’s backlight turns ON to show
that the remote is set to AUX mode. Make sure to keep the remote in
AUX mode to use the buttons as described in this section.
For AUX mode only. The first
group of flashes tells you
what the AUX mode controls.
A quick flash (zero) before
the three-digit code is for a
TV; one regular flash is for a
VCR or DVD player; and two
flashes is for a tuner or
amplifier.
For example, if the TV code is 570,
the AUX mode button flashes once
quickly (indicating 0 for TV),
pauses, flashes five times, pauses,
flashes seven times, pauses, and
flashes once quickly.
Some of the features described below may not apply to your
tuner or amplifier. See the device owner’s manual for details
about the device’s features. If a remote control button is not
described in this section, it does not work for a tuner or
amplifier.
To Next Page
Loading...
