Page 35
Using Timers
EVENT TIMER FREQUENCIES
Once—Applies to a one-time program. If the program time changes, this
timer operates at the new time. The receiver deletes this timer when the
timer operates.
Mon.-Fri.—Applies to a program that is scheduled for Monday through
Friday on the same channel at the same time each day.
Daily—Applies to a program that is scheduled for Monday through Sunday
on the same channel at the same time each day.
Weekly—Applies to a program that is scheduled for once a week on the
same channel at the same time on the same day.
Note: You can only record using your VCR the program to which the
receiver is tuned. If you open any menu (including the Program Guide)
while recording a program on videotape, the menu also will be recorded. If
a program time changes by more than 24 hours, the timer does not operate.
BEFORE AN EVENT TIMER STARTS
A few minutes before an event timer operates, the receiver displays a small
blinking “clock” symbol on the TV screen. This symbol disappears when
the program begins. While the symbol is displayed, you may do either one
of the following.
• Press the remote control CANCEL button to clear the
symbol from the TV screen. This does not affect the timer;
it still operates.
• Press the remote control INFO button to see more
information on the event timer. If you do this, you will
have the following choices:
Select the
OK or Cancel option to continue with the event timer.
Select the
Stop Timer or No option to stop the event timer.
Note: This choice stops only this instance of a Mon.-Fri., Daily or Weekly
timer. The timer operates the next time it is scheduled. To stop all operations
of such a timer, you must delete the timer. For a
Reminder Event Timer,
instead of having the option to stop the timer, you have the option to tune to
the program.
or
or
To Next Page
Loading...
