Dish Network Hopper 3 - Remote Pairing and Mode Issues; Remote Not Listed or Un-paired; Remote Mode LED Indicator Lights

27
If your remote is not listed or cannot be un-paired on the System Info screen, then
complete the following steps:
1 Press and hold SAT until the Mode Indicator lights and then release. If the Mode
Indicator does not light up, the remote isn’t paired. Use the Locate Remote button
onthefrontpaneloftheHopper3receivertondapairedremote(seeLocating the
Remote on page 11).
2 Press and hold the HOME and GUIDE buttons simultaneously until the remote beeps.
The remote is now unpaired.
When I press a button on the remote, Mode LED indicator lights.
What to do:Whenbatteriesarerstinsertedintotheremote,theremotegoesthrough
an initializing process. This process takes about ten seconds, and pressing a key while
theremoteisbootingupcausestheSAT,TV,andAUXmodebuttonstoash.Ifaremote
stays in this state for longer than two minutes, replace the batteries (see page 4).
Hopper_3_UserGuide.indd 27 8/17/2015 1:05:42 PM