Disty base duo plus - Call Assignment of the Handsets; Line Assignment for Outgoing Calls; Programming Example

93Programming mode
3.2.1 Call assignment of the handsets
Function Parameter Line no. Mob no.
code
Call assignment 11 1…2 0…9 #
For each line, incoming calls can be assigned to a maximum of 4 call
destinations. Call destinations are the handsets 1 to 8 and hunt group call
9. With call destinations 1-8, the caller’s telephone number is displayed
via CLIP. Call destination 9 signals all registered handsets but without
CLIP display, call waiting will not be signalled.
The analogue port of distybase duo plus will not be rung by hunt group
destination 9.
Not all types of GAP compliant handsets are able to receive calls by hunt
group destination 9.
Programming example:
Calls to line 1 should be signalled on handsets 1, 3 and 6 with CLIP
display.
Calls to line 2 should be signalled on handsets 3, 4 and 5 with CLIP
display. And signalled without CLIP display on other handsets.
Procedure:
1) Activate programming mode
2) Enter
111136#
3) Enter
1123459#
4) Close programming mode
Factory setting: 1, 2, 3, 9
3.2.2 Line assignment for outgoing calls
Independent of setting of parameter 12 it is possible to seize a specific
line by using the access codes.
Function Parameter Mob. no. Inputs
code
Line assignment 12 0…8 0 #
When making an external call, any free telephone line is used.
Operating Instructions