14
3Programming mode
If no direct dialling is detected within 10 seconds, the signalling is carried
out according to the call assignment. If the selected handset does not
answer, the signalling process is continued according to the call
assignment.
Also activated is the integrated fax switch. When receiving a fax call it will
be automatically routed to the subscriber which is set up in parameter 14
as fax subscriber.
Factory setting: 0
3.2.9 Call-waiting
Be aware that hunt group calls will not be signalled by a call waiting tone.
Function Parameter Inputs
code
Call-waiting 22 0 #
If an external or internal call is present, another external call for that
handset will not be signalled.
Call-waiting 22 1 #
If an external or internal call is present, another external call for that
handset will be signalled by a call waiting tone.
Factory setting: 1
3.2.10 Flash time
Function Parameter Inputs
code
Flash time 23 0…255 #
The flash time can be changed according to line requirements, in
increments of 10 ms.
Factory setting: 20, which is equal to 200 ms
To Next Page
Loading...