173Programming mode
3.2.14 Blacklist
The blacklist monitors the selected telephone numbers for the assigned
subscribers. If a blacklisted telephone number is dialled, the subscriber
hears a busy tone. The blacklist is divided into the exclusion area and the
release area. The release area defines exceptions within the blacklist.
Depending on the area, 5 entries can each be made, consisting of 6
figures each. If a subscriber has the authorisation to make international
calls, none of the phone or fax numbers they dial starting with 00 will be
checked by the blacklist.
Function Parameter Mob. no. Inputs
code
Blacklist 40 0…8 0 #
The subscriber’s dialling is not controlled by the blacklist.
Blacklist 40 0…8 1 #
The subscriber’s dialling is controlled by the blacklist.
Factory setting: 0
Function Parameter Entry Inputs
code no.
Exclusion area 41 1…5
No.
max. 6
figures
#
Entry is stored.
Exclusion area 41 1…5 #
Entry is deleted.
Release area 42 1…5
No.
max. 6
figures
#
Entry is stored.
Release area 42 1…5 #
Entry is deleted.
Factory setting: No entry in exclusion area or release area.
Operating Instructions
To Next Page
Loading...