Ditch Witch Cx Series - Page 94

Cx Series Operator’s Manual Service - 93
Procedures
C16x
1. Remove wing nuts to remove cover.
2. Wipe inside of housing and wash cover.
3. Inspect element (shown). Replace if needed.
4. Insert element and ensure it is seated
correctly.
5. Install cover and secure with wing nuts.
C24x & C30x
1. Remove air filter cover (4).
2. Remove primary (2) and secondary (3)
elements.
3. Wipe inside of housing (1) and wash cover.
4. Inspect elements. Replace if needed.
5. Insert secondary element and ensure it is
seated correctly.
6. Insert primary element.
7. Replace cover with dust ejector (5) facing
down.
t57om014w.eps
1
2
3
4
5