3
IP1776EN 2012-02-20
1. GENERAL SAFETY PRECAUTIONS
This installation manual is intended for professionally competent personnel only.
The installation, the power connections and the settings must be completed in conformity with Good
:orNing Methods and with the regulations in force.
Before installing the product, carefully read the instructions. Bad installation could be ha]ardous. The pacNaging
materials (plastic, polystyrene, etc.) should not be discarded in the environment or left within reach of children,
as these are a potential source of hazard.
Before beginning the installation checN that the product is in perfect condition.
'o not install the product in explosive areas and atmospheres the presence of Àammable gas or fumes re-
presents a serious threat to safety.
The safety devices (photocells, sensitive edges, emergency stop, etc.) must be installed taNing into account
the provisions and the directives in force, Good :orNing Methods, the installation area, the functional logic of
the system and the forces developed by the automation.
Before maNing power connections, checN that the rating corresponds to that of the mains supply. A mul-
tipolar disconnection switch with a contact opening gap of at least 3 mm must be included in the mains
supply. ChecN that upstream of the electrical installation an adequate residual current circuit breaNer and an
overcurrent cut out are ¿tted.
When requested, connect the automation to an effective earthing system carried out as indicated by current
safety regulations.
During installation, maintenance and repair operations, cut off the power supply before opening the cover to
access the electrical parts.
To handle electronic parts, wear earthed antistatic conductive bracelets. The manufacturer of the moto-
risation declines all responsibility in the event of components which are not compatible with the safe and
correct operation of the product.
For repairs or replacements of products only original spare parts must be used.
Intelligent Security & Fire Ltd.
To Next Page
Loading...
