4
IP1776EN  2012-02-20
3.1 Applications
3. TECHNICAL DATA
i
NOTE: the given operating and performance features can only be guaranteed with the use of DITEC
accessories and safety devices.
4. CONNECTION OF POWER SUPPLY
Fix the control panel permanently. Pass the cables along from the lower side of the container.
Before connecting the power supply, maNe sure the plate data correspond to that of the mains power supply.
An omnipolar disconnection switch with minimum contact gaps of 3 mm must be included in the mains supply.
ChecN that upstream of the electrical installation there is an adequate residual current circuit breaNer and a
suitable overcurrent cutout.
Use a 3x1.5 mm FROR 450/750V type electric cable and connect to the terminals L (brown), N (blue),
(yellow/green) in the automation.
Secure the cable using a special cable clamp.
MaNe sure there are no sharp edges that may damage the power supply cable.
Connection to the mains power supply, in the section outside the automation, is made with independent channels
and separated from the connections to the control and safety devices.
2. EC DECLARATION OF CONFORMITY
Manufacturer: DITEC S.p.A.
Address: via Mons. Ban¿, 3 21042 Caronno P.lla (VA) - ITALY
declares that the control panel VIVAH is in conformity with the provisions of the following EC directives:
EMC Directive 2004/108/EC;
Low Voltage Directive 2006/95/EC.
Caronno Pertusella, 13-12-2010 Silvano Angaroni
(Managing Director)
VIVAH
Power supply 230 V~ / 50-60 Hz
F1 fuse F2A
F2 fuse F2.5A
Motor output 24 V= / 2 x 12 A max
Accessories power supply 24 V= / 0.5 A
Temperature -20 °C / +55 °C
Degree of protection IP55
Box dimensions 238x357x120
ano
in
Intelligent Security & Fire Ltd.
To Next Page
Loading...
