11
SET NOT AVAILABLE TIMES
Password protected. Before entering or changing this
setting you must enter the password if one has been
assigned. This mode allows up to 4 different time
periods that use of the machine may be restricted.
To set Not Available Times enter the “SETUP MODE”
by opening the service door and pressing the Service
Button 3 times. Press the number 3 key; the display
will scroll “SET NOT AVAILABLE TIME”. Press the “*”
key and the display will show ”SHUTDOWN”. Press
the “A” key and the display will show “BLOCK 1”
which allows selection set up. Press the “*” key and
the controller will begin displaying selections currently
belonging to block until all have been displayed or the
“*” key is pressed and display will show “ITEM”. There
are now three (3) choices:
1) ALL SELECTIONS. Press the “*” key and
all selections in the vender will be set for
not available.
2) ONE TRAY. Pressing the letter of the
shelf (tray) followed by the “*” key will set
control for all selections on that shelf.
3) SINGLE SELECTION. Press the desired
selection number or numbers
corresponding to the selections that
require the set not available times.
Press the key buttons again and the display will flash
“DISABLED” and return to “ITEM”. Priority will be
given to the higher ranked method If one selection on
the A tray was set to “ENABLE” using option 3 above
and you wish to change the remaining selections on
that tray using option 2, the Setting for the entire tray
would take precedence. Conversely, if the tray was
set using option 2 first followed by the single selection
using option 3, the setting for the remainder of the
shelf would remain and the new set not available
setting would take affect. If “DISABLED” the selection
will be blocked during the scheduled time period.
Press the “CLR” key will exit the selection setup &
start the schedule setup. “START TIME” will scroll on
display once and change to “HOUR 00”. Enter the
hour (00 – 23) and press the “*” key. The display will
read “MIN 00”. Enter the minutes (00 – 59) and press
the “*” key. “END TIME” will scroll on display once
and change to “HOUR 00”. Enter the hour (00 – 23)
and press the “*” key. The display will read “MIN 00”.
Enter the minutes (00 – 59) and press the “*” key.
“DAY” will show on the display. To change press the
“*” key and the display will read “SAT”. Use the “A”
key to scroll through the days. When the desired day
is displayed, press the “*” key. Press the “CLR” key to
move to “BLOCK 2”.
POINTS TO REMEMBER:
• Before setting Not Available times and days, it
is recommended you check the DATE/TIME
settings.
• All times entered must be in 24 hour format.
To Next Page