dji AVATA - Page 47

DJI Avata
User Manual
47
© 2022 DJI All Rights Reserved.
1. Flight Direction Indicator
When the motion controller is stationary, it indicates the midpoint of the screen. When the motion controller is
moved, it indicates the change of the aircraft orientation or gimbal tilt.
2. Storage Information
Displays the remaining capacity of the aircraft and goggles. A ashing icon will appear when recording.
3. Gimbal Slider
Displays the gimbal tilt angle when the gimbal slider or dial is toggled.
4. Prompts
Displays notications and information such as when a new mode is applied or battery level is low.
5. Goggles Battery Level
Displays the battery level of the goggles. The goggles will beep when the battery level is too low.
6. GNSS Status
Displays the current GNSS signal strength.
7. Remote Control Device and Video Downlink Signal Strength
Displays the remote control signal strength between the aircraft and remote control device and the video
downlink signal strength between the aircraft and the goggles.
8. Remaining Flight Time
Displays the remaining ight time of the aircraft after starting the motors.
9. Aircraft Battery Level
Displays the current battery level of the Intelligent Flight Battery on the aircraft.
10. Distance to the Ground
Displays the current altitude information of the aircraft from the ground when the aircraft is less than 10 m
above the ground.
11. Flight Telemetry
Displays the horizontal distance (D) and speed as well as vertical distance (H) and speed between the aircraft
and the Home Point.
12. Flight Modes
Displays the current ight mode.
13. Home Point
Indicates the location of the Home Point.
The goggles will display the screen saver if they are not used for an extended period or disconnected
from the aircraft. Press any button of the goggles or relink them to the aircraft to restore the video
transmission display.
If the devices are not used for an extended period, it may take longer than usual to search for the
GNSS signal. If the signal is unobstructed, it takes approximately 20 seconds to search for the GNSS
signal when powering on and o within a short period.
If you select to record with both the aircraft and the goggles, the storage information of both the
aircraft and goggles will be displayed on the home screen. If you select to record with only the aircraft
or goggles, only the storage information of the corresponding device will be displayed.