DJI Avata
User Manual
63
© 2022 DJI All Rights Reserved.
Pre-Flight Checklist
1. Make sure the goggles battery, remote control devices, Intelligent Flight Battery, and mobile device are fully
charged.
2. Make sure the propellers are mounted correctly and securely.
3. Make sure the Intelligent Flight Battery and goggles battery are properly connected and secure.
4. Make sure the USB-C port and microSD card slot cover is correctly and securely sealed.
5. Make sure the gimbal and camera are functioning normally.
6. Make sure that there is nothing obstructing the motors and that they are functioning normally.
7. Make sure that the goggles are functioning normally and display the video transmission.
8. Make sure that the gimbal protector is detached and the camera lens and the sensors are clean.
9. Make sure that the goggles antennas are installed securely and the remote controller antenna is lifted.
10. Only use genuine DJI parts or DJI authorized parts. Unauthorized parts may cause system malfunctions and
compromise ght safety.
Starting/Stopping the Motors
DJI Motion Controller
OR
Lock Button
Press the lock button twice to start the motors of the aircraft.
Press and hold the lock button to make the aircraft take o automatically, ascend to approximately 1.2 m, and
hover.
Press and hold the lock button while the aircraft is hovering to land it automatically and stop the motors.
DJI FPV Remote Controller 2
Starting the Motors
Normal/Sport mode:
A CSC is used to start the motors. Push both sticks to the inner or outer bottom corners to start the motors.
Once the motors start spinning, release both sticks simultaneously.
To Next Page
Loading...
