dji AVATA - Start;Stop Button

DJI Avata
User Manual
57
© 2022 DJI All Rights Reserved.
Manual mode is disabled by default. Make sure that the switch is set to Manual mode in the goggles before
switching to Manual mode. The aircraft will remain in Normal or Sport mode if the switch is not set to Manual
mode in the goggles. Go to Settings > Control > Remote Controller > Button Customization, and then set Custom
Mode to Manual mode.
Before using Manual mode, it is recommended to tighten the F2 screw on the rear of the throttle stick so that the
stick does not return to the center and adjust the F1 screw to make sure the stick resistance is suitable.
When using Manual mode, the aircraft has no flight assistance functions such as automatic
stabilization. Before using Manual mode, practice flying in Manual mode using DJI Virtual Flight to
ensure that you can y safely.
Only adjust the throttle stick before the aircraft takes o. DO NOT adjust during ight.
Start/Stop Button
When using Manual mode, press twice to start or stop the motor.
When using Normal or Sport mode, press once to cancel Low Battery RTH when the countdown appears in the
goggles.
Flight Pause/RTH Button
Press once to make the aircraft brake and hover in place. Make sure that the pitch stick and roll stick return to the
center and push the throttle stick to resume control of the ight. If the aircraft is performing RTH or auto landing,
press once to exit.
When the aircraft is in Manual mode, press the button to make the aircraft brake and hover in place. The aircraft
attitude returns to level and the ight mode automatically switches to Normal mode.
Press and hold the RTH button until the remote controller beeps to indicate that RTH has started. Press the
button again to cancel RTH and regain control of the aircraft. Refer to the Return to Home section for more
information about RTH.