DJI Avata
User Manual
64
© 2022 DJI All Rights Reserved.
Manual mode:
Make sure the throttle stick is in the lowest position and press the start/stop button twice to start the motors.
+
Throttle Stick
Stopping the Motors
Normal/Sport mode:
The motors can be stopped in two ways:
Method 1: When the aircraft has landed, push the throttle stick down and hold. The motors will stop after three
seconds.
Method 2: When the aircraft has landed, push the throttle stick down, and perform the same CSC used to start
the motors. Release both sticks once the motors have stopped.
Method 1
Method 2
OR
Manual mode:
Press the start/stop button twice to stop the motors once the aircraft has landed.
Stopping the Motors Mid-Flight
When using Normal or Sport mode, the motors can only be stopped by pressing the lock button twice on the
motion controller or performing a CSC on the remote controller mid-ight in an emergency situation such as if
the aircraft has a stalled motor, is involved in a collision, is rolling in the air, is out of control, or is ascending or
descending quickly. The default setting can be changed in goggles.
When using the Manual mode, press the start/stop button twice on the remote controller to stop the motors at
any time.
Stopping motors mid-ight will cause the aircraft to crash.
To Next Page
Loading...
