dji AVATA - Video Suggestions and Tips

DJI Avata
User Manual
65
© 2022 DJI All Rights Reserved.
Flight Test
Takeo/Landing Procedures
1. Place the aircraft in an open, at area with the aircraft rear facing towards you.
2. Power on the goggles, remote control device, and the aircraft.
3. Wait until the aircraft status indicator blinks green slowly to indicate that the Home Point has been recorded
and put on the goggles.
4. Start the motors.
5. For DJI motion controller, press and hold the lock button, to make the aircraft take o automatically, ascend to
approximately 1.2 m, and hover.
For DJI FPV remote controller V2, gently push the throttle stick up to take o.
6. For DJI motion controller, press and hold the lock button while the aircraft is hovering to land it automatically
and stop the motors.
For DJI FPV remote controller V2, pull the throttle stick down to land the aircraft. Stop the motors after landing.
7. Power o the aircraft, goggles, and remote control device.
Video Suggestions and Tips
1. The pre-ight checklist is designed to help you y safely and shoot videos during ight. Go through the full pre-
ight checklist before each ight.
2. Select the desired gimbal operation mode.
3. It is recommended to use Normal mode to take photos or record videos.
4. DO NOT y in bad weather such as on rainy or windy days.
5. Choose the camera settings that best suit your needs.
6. Perform ight tests to establish ight routes and preview scenes.
7. Push the control sticks gently to ensure smooth and stable movement of the aircraft.
8. When using Manual mode, y in an open, wide, and sparsely populated environment to ensure ight safety.
It is important to understand the basic ight guidelines, both for your protection and for the safety
of those around you.
DO NOT forget to read the safety guidelines.