14
©
2018 DJI All Rights Reserved.
INSPIRE 2 SERIES
User Manual
Atti Mode Warning
The aircraft will enter A-mode in the following two instances:
Passive:
When there is weak GPS signal or when the compass experiences interference where the
Vision System is unavailable.
Active:
Users toggle the ight mode switch to A-mode.
In A-mode, the Vision System and some advanced features are disabled. Therefore, the aircraft
cannot position or auto-brake in this mode and is easily affected by its surroundings, which may
result in horizontal shifting. Use the remote controller to position the aircraft.
Maneuvering the aircraft in A-mode can be difcult. Before switching the aircraft into A-mode, make
sure you are comfortable ying in this mode. DO NOT y the aircraft too far away as you might lose
control and cause a potential hazard.
Avoid ying in areas where GPS signal is weak, or in conned spaces. The aircraft will otherwise be
forced to enter A-mode, leading to potential ight hazards, please land it in a safe place as soon as
possible.
Flight Status Indicator
The Inspire 2 comes with the Front LED, Rear LED and Aircraft Status Indicator. The positions of
these LEDs are shown in the gure below:
The Front LEDs show the orientation of the aircraft. The Front LEDs glow solid red when the aircraft
is turned on to indicate the front (or nose) of the aircraft (Front and rear LEDs can be turned off
in the DJI GO 4 app). The Aircraft Status Indicator communicates the system status of the ight
controller. Refer to the table below for more information about the Aircraft Status Indicator.
Aircraft Status Indicator Description
Normal
Red, yellow, green, blue and purple ashes Turning On and Self Diagnostic Testing
×4 Four yellow ashes Warming Up
Slow green ashing P-mode with GPS*
×2 Two green ashes
P-mode with Forward and Downward
Vision Systems*
Slow yellow ashing
No GPS and Forward and Downward
Vision Systems
Fast green ashing Braking
Rear LEDFront LED
Aircraft Status Indicator
To Next Page
Loading...
Need help?
General
