44
©
2018 DJI All Rights Reserved.
INSPIRE 2 SERIES
User Manual
Status LED Alarm Remote Controller Status
—
Solid Red ——
The remote controller set as "Master" but it is not
connected with the aircraft.
—
Solid Green ——
The remote controller set as "Master" and it is
connected with the aircraft.
—
Solid Purple ——
The remote controller set as "Slave" but it is not
connected with the aircraft.
—
Solid Blue ——
The remote controller set as "Slave" and it is
connected with the aircraft.
Slow Blinking
Red
D-D-D
......
Remote controller error.
/
Red and Green/ Red and
Yellow Alternate Blinks
None HD Downlink is disrupted.
RTH LED Sound Remote Controller Status.
—
Solid White chime Initiate RTH procedure.
Blinking White
D
. . .
Send RTH command to aircraft.
Blinking White DD
.. .. ..
Aircraft returning to Home Point.
The Remote Status Indicator will blink red, sound an alert, when the battery level is critically
low.
Linking the Remote Controller
The remote controller is linked to your aircraft before delivery. Linking is only required when using a
new remote controller for the rst time. Follow these steps to link a new remote controller:
1. Power on the remote controller and connect to the mobile device. Launch DJI GO 4 app.
2. Power on the Intelligent Flight Battery.
3. Enter camera view and then tap “Linking Remote Controller” button as shown below.
Charge Mobile Phone
Linking Remote Controller
Button Customization
Not Defined
Never
C1
C2 Not Defined
Customize with the C1 and C2 button on the back of the Remote Controller.
Remote Controller Settings
To Next Page
Loading...
Need help?
General
