dji MATRICE M30 EU

DJI M30 Series
User Manual
20
©
2023 DJI All Rights Reserved.
3. The aircraft begins to land when it reaches above the Home Point.
•
The aircraft may not be able to return to the Home Point if the positioning performance is
poor. In case of loss of remote controller signal, the aircraft may enter ATTI mode and will
automatically land.
•
It is important to set a suitable RTH altitude before each ight. Launch DJI Pilot 2 and set the
RTH altitude. The default RTH altitude is 100 m.
•
The aircraft cannot bypass obstacles during RTH if the lighting and environment conditions are
unsuitable for the vision systems.
•
The aircraft may not be able to return to a Home Point when the wind speed is too high. Fly
with caution.
•
Pay extra attention to small or ne objects (such as tree branches or power lines) or transparent
objects (such as water or glass) during RTH. Exit RTH and control the aircraft manually in an
emergency.
RTH Procedure
1. The Home Point is recorded.
2. Advanced RTH is triggered.
3. The aircraft brakes and hovers in place. When RTH begins:
•
The aircraft lands immediately if the RTH distance is less than 5 m.
•
If the RTH distance is farther than 5 m, the aircraft will plan the best path according to the RTH
settings, lighting, and environmental conditions.
4. The aircraft will y automatically according to the RTH settings, environment, and transmission signal
during RTH.
5. The aircraft lands and the motors stop after reaching the Home Point.
RTH Settings
Advanced RTH will plan the RTH path using Preset RTH.
Preset: