20
©
2022 DJI All Rights Reserved.
DJI Mini 3 Pro
User Manual
Pay attention to the ight environment. The Vision Systems and Infrared Sensing System only work
in certain scenarios and cannot replace human control and judgment. During a ight, always pay
attention to the surrounding environment and the warnings on DJI Fly, and be responsible for and
maintain control of the aircraft.
When no GNSS signals are available, the Downward Vision System works best at an altitude from 0.5
to 12 m. Extra caution is required if the altitude of the aircraft is above 12 m as the Vision Systems
may be aected.
The Downward Vision System may not function properly when the aircraft is flying over water.
Therefore, the aircraft may not be able to actively avoid the water below when landing. It is
recommended to maintain flight control at all times, make reasonable judgments based on the
surrounding environment, and avoid over-relying on the Downward Vision System.
The Vision Systems cannot work properly over surfaces without clear pattern variations or where the
light is too weak or too strong. The Vision Systems cannot work properly in the following situations:
a) Flying over monochrome surfaces (e.g., pure black, white, red, or green).
b) Flying over highly reective surfaces.
c) Flying over water or transparent surfaces.
d) Flying over moving surfaces or objects.
e) Flying in an area with frequent and drastic lighting changes.
f) Flying over extremely dark (< 10 lux) or bright (> 40,000 lux) surfaces.
g) Flying over surfaces that strongly reect or absorb infrared waves (e.g., mirrors).
h) Flying over surfaces without clear patterns or texture (e.g., power poles).
i) Flying over surfaces with repeating identical patterns or texture (e.g., tiles with the same design).
j) Flying over obstacles with small surface areas (e.g., tree branches).
Keep the sensors clean at all times. DO NOT block or tamper with the sensors.
DO NOT obstruct the Infrared Sensing System.
Vision System cameras may need to be calibrated after being stored for an extended period. In such
cases, a prompt will appear in DJI Fly and calibration will start automatically.
DO NOT y when it is rainy, smoggy, or the visibility is lower than 100 m.
Check the following each time before takeo:
a) Make sure there are no stickers or any other obstructions over the glass of the infrared sensing
systems and vision systems.
b) Use soft cloth if there is any dirt, dust, or water on the glass of the infrared sensing and vision
systems. DO NOT use any cleaning product that contains alcohol.
c) Contact DJI Support if there is any damage to the glass of the Infrared Sensing System or Vision
Systems.
Intelligent Flight Mode
FocusTrack
FocusTrack includes Spotlight 2.0, Point of Interest 3.0, and ActiveTrack 4.0.
Spotlight 2.0
Control the aircraft manually while the camera remains locked on the subject. The mode supports the
To Next Page
Loading...
Need help?
General
