System Parameters Programming Section 2.4
Description Command Section Default Value
Phone / Intercom Mode * 0 6 2.4.1 Phone
Single / Multiple Systems * 6 1 2.4.2 Single
System Attention Number * 6 2 2.4.3 7
Single or Double Ring * 6 3 2.4.4 Double
Number of Rings to Resident * 6 4 2.4.5 5
Talk Time * 0 8 2.4.6 60 Sec.
Relay Strike Time * 0 3 2.4.7 1 Sec
Tone Open Numbers * 0 5 2.4.8
Relay 1: 9 8 7 6
Relay 2: 5 4 3 2
Answer Incoming Call on X Rings * 1 8 2.4.9 6
Hang-up Tone * 1 7 2.4.10 0
Call Waiting On / Off * 2 0 2.4.11 ON
Turn Speaker On From Outside Call * 1 6 2.4.12 N / A
Set Call Forwarding Microphone Gain & Speaker Volume * 1 1 2.4.13 7 1
Directory Codes Section 2.5
Description Command Section Default Value
Directory Codes 24 – 50 Dial Phone Number * 4 1 2.5.1 Empty
Delete Single Phone Number from Directory Codes 24 – 50 * 4 2 2.5.2 N / A
Delete All Phone Numbers from Directory Codes 24 - 50 * 4 3 2.5.3 N / A
Devices Section 2.6
Description Command Section Default Value
Program Simple Access Code * 0 2 2.6.1 Empty
Program Number of RS-485 Devices * 0 9 2.6.2
Program RS-485 Device Off-Line Function * 0 7 2.6.3
Program Access Code * 7 0 2.6.4 Empty
Delete Access Code * 7 1 2.6.5 N / A
Delete All Access Codes * 7 2 2.6.6 N / A
Program Temporary Access Codes * 7 3 2.6.7 Empty
Delete Temporary Access Code * 7 4 2.6.8 N / A
Delete All 10 Temporary Access Codes * 7 5 2.6.9 N / A
Time Functions Section 2.7
Description Command Section Default Value
Program Calendar Chip * 3 3 2.7.1 Empty
Program Call Forward Time * 3 7 2.7.2 Empty
Program Call Forward Number * 1 0 2.7.3 Empty
Program Do Not Disturb * 3 4 2.7.4 Empty
Program Relay Hold Schedule * 3 5 2.7.5 Empty
Program Time Zones * 3 6 2.7.6 Empty
Miscellaneous Section 2.8
Description Command Section Default Value
Restore Defaults * 9 0 2.8.1 N / A
Erase Transaction Log * 9 1 2.8.2 N / A
Page 32 1812-162-B-6-09
To Next Page
Loading...
