1812-162-B-6-09 Page 37
2.4.13 Set Call Forwarding Microphone Gain and Speaker Volume
Default setting is 71.
This adjustment is required only if call forwarding or directory code dialing is being used. This step
will adjust the microphone gain (the remote handset loudness) and the speaker volume (the 1812
loudness) during call forwarding operation. You may have to perform these steps several times to get
the optimal microphone gain and speaker volume adjustment.
Be sure that you have a call forward phone number programmed (2.7.3) and call forwarding is turned
on (2.7.2).
Before making any adjustments, do a test call as the programmed defaults may work fine for you and
no additional adjustments may be necessary. If adjustments are made, you will need to do a call
forward test call after each adjustment to determine if the result is to your liking.
The valid values for both the microphone gain and speaker volume are 0 through 9. These values
are entered as a two-digit number in step 2 below. The first digit is the microphone gain; the second
digit is the speaker volume. The default setting is 71, which means that the microphone gain is set to
7 and the speaker volume is set to 1. A higher value increases the loudness where as a lower value
decreases the loudness.
1. Press * 1 1 and enter the MASTER CODE. [ * 1 1 _ _ _ _ (beep)]
2. Enter a two-digit microphone gain and speaker loudness setting, then press *.
[ _ _ * (beep)]
3. Press 9 9 9 9 then press *. [ 9 9 9 9 * (beep)]
4. The programming sequence will end itself automatically. [beeeeeep]
To Next Page
Loading...
