DLab D2012 plus - Rotor Preparation; Prepare Samples; Inject Samples into Tubes; Tube Balancing

High Speed Mini Micro-Centrifuge
9
7. Rotor Preparation
7.1 Prepare the samples
7.2 Inject the samples into tubes.
CAUTION：
 Do not overload samples into the centrifuge which will cause leaking.
 Do not exceed the actual capacity allowed in the user manual.
7.3 Keep the tubes balance
 Although the centrifuge can accept sample balancing by eye, we recommend that you keep this
centrifuge in a well-balanced condition to extend its life expectancy.
 Never intentionally run the centrifuge under unbalanced condition even though the allowable
imbalance is not exceeded.
7.4 Inspect the rotor
Check the rotor for corrosion or scratches before using.
CAUTION：
 Any abnormality such as corrosions or scratches are found, stop using the rotor and contact our service
center.
 Only manufacturer’s rotors must be used with the unit.
7.5 Symmetrically load centrifuge tubes in rotor
CAUTION：
 Make sure the rotor lid is securely fixed on the rotor, as well as the rotor and shaft are tightened.
Otherwise, the rotor may be moved off while rotating and cause damage of the centrifuge and rotor.