DLab D2012 - Tube Care and Sterilization; Notice; Autoclaving; Tubes

High Speed Mini Micro-Centrifuge
17
0.5ml micro
tube
A05P2
15000
12780
D2012
plus
A12-2P
02
1.5/2.0ml
tube
15000
15100
2.0g/ tube
5mm/ tube
0.2ml PCR
tube
A05P2
15000
11700
0.5ml micro
tube
A02P2
15000
12780
11.1.3 Notice
 The centrifuge rotor can separate sample which density lower than 2.0g/ml. if the separated samples
density is over 2.0g/ml, please calculate allowable speed depending on the following formula.
Allow Speed (rpm)= Maximum speed×(2.0(g/ml)/Sample density (g/ml))
1/2
11.1.4 Autoclaving
A12-2 rotor is manufactured in high-strength aluminum alloy material and can be autoclaved: 121℃ (1.0kg/cm2),
20 minutes.
A12-2P rotor is made of plastic, cannot be high-pressure sterilization and UV irradiation, only ordinary
sterilization can be used.
CAUTION:
 The lid of the rotor is made of plastics, can not be high-pressure sterilization, only ordinary sterilization
can be used.
11.2 Tubes
11.2.1 Cleaning and sterilizing tubes
Table 11.2 Cleaning and sterilizing conditions for tubes
O：Applicable X：Inapplicable
Condition Material
PA
PC
PP
Cleaning
Cleaning fluids
Acidic（pH5 or lower）
X
X
X
Acidic（higher than pH5 ）
O
O
O
Alkaline（higher than pH9 ）
O
X
O
Alkaline（pH9 or lower）
O
O
O
Neutral（pH7）
O
O
O
Warm water(up to 70℃)
O
O
O
Ultrasonic cleaning
Neutral detergent（pH7）
O
O
O