DLab OS40-Pro - Trial Running

5
5. Trial Running
Follow the instructions below to trial operate:
LCD digital LED digital
•Ensure the required operating voltage and power supply
voltage matched.
•Ensure the socket must be earthed reliably.
•Connect the power cable，ensure the power on and begin
self-checking.
•Rotate the stirring button and set stirring speed.
•Press stirring button and start stirring.
•Press again the stirring button and stop stirring.
•Ensure the required operating voltage and power supply
voltage matched.
•Ensure the socket must be earthed reliably.
•Counter-clockwise rotate the speed control button to the
end before switch on instrument.
•Connect the power cable，ensure the power on and begin
self-checking.
•Clockwise rotate the speed control button to the target
speed value, and start stirring function.
•Counter-clockwise rotate the speed control button to stop
stirring function.
If these operations above are normal, the instrument is ready to operate. If not, the instrument may be damaged during
transportation, please contact technical support of manufacturer/supplier.
Note: Do not touch components of high-speed running instrument during operation to avoid damage and harm.