DLS 50 - Baud Rate; Data Format; Flow Control

Remote Control
Page 17
4.2.1 Baud Rate
The DLS 50 supports the following baud rates:
300, 600, 1200, 2400, 4800, 9600, 19 200 and 38 400 bits per second.
The default is 9600 bps.
4.2.2 Data Format
The DLS 50 can use any of the following combinations of parity, character size, and
number of stop bits:
E71, O71, E72, O72, N72, E81, O81, N81 and N82
Where:
E = even parity
O = odd parity
N = no parity
the second digit is the character size
the third digit is the number of stop bits
The default value is N81.
4.2.3 Flow Control
The flow control allows the receivers to stop and to restart the data transmission in order
to prevent data loss.
Both the computer program and the DLS 50 must be set with the same flow control
selection. Note that some communication programs may only support some of the 5
flow control options that the DLS 50 has, and in some cases, the terminology may differ.