DLS 50 - Mains Fuse Type; Connections to a Power Supply; Operating Environment; Class of Equipment

Safety
Page 44
8.1.4 Mains Fuse Type
The fuse type used is specified in the specifications section of this manual.
8.1.5 Connections to a Power Supply
In accordance with international safety standards, the unit uses a three-wire power
supply cord. When connected to an appropriate AC power receptacle, this cord grounds
the equipment chassis.
8.1.6 Operating Environment
To prevent potential fire or shock hazard, do not expose the equipment to any source of
excessive moisture.
8.1.7 Class of Equipment
The unit consists of an exposed metal chassis that is connected directly to earth via the
power supply cord. In accordance with the HARMONIZED EUROPEAN STANDARD
EN 61010-1 1993, it is classified as a Safety Class I equipment .
8.2 INSTRUCTIONS
The following safety instructions must be observed whenever the unit is operated,
serviced or repaired. Failing to comply with any of these instructions or with any
precaution or warning contained in the Operating and Reference Manual is in direct
violation of the standards of design, manufacture and intended use of the equipment.
DLS TESTWORKS LTD. assumes no liability for the customers failure to comply with
any of these requirements.