Remote Control
Page 25
On power-on, the register is cleared if the Power-on Status Clear bit is 1, or restored if
the bit is 0 (see *PSC for more details).
*ESE? EVENT STATUS ENABLE QUERY
Type: Status command
Function: An integer value between 0 and 255 representing the value of the
Event Status Enable Register (ESER) is placed in the output queue.
The possible values are described in the *ESE command section.
*ESR? EVENT STATUS REGISTER QUERY
Type: Status command
Function: An integer value between 0 and 255 representing the value of the
Event Status Register (ESR) is placed in the output queue. Once the
value is placed in the output queue, the register is cleared. The
possible values are described in the *ESE command section.
*IDN? IDENTIFICATION QUERY
Type: System command
Function: Returns the ID of the unit. Upon receiving this command the DLS 50
will put into the output queue the following string:
DLSTESTWORKS LTD, DLS 50 <Gauge>- <MaxLen
Unit>,<SN>,<Ver>
where:
<Gauge> is the gauge installed in the unit
<MaxLen Unit> is the maximum length supported by the DLS 50,
followed by the unit of the length
<SN> is the serial number of the unit
<Ver> is the revision level of the control firmware (always
2 digits)
To Next Page
Loading...