EasyManua.ls Logo

DLX LUXE - 1.1 Quick Start Guide

DLX LUXE
36 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
GET TO KNOW YOUR NEW LUXE
®
MARKER
OrIENTaTION 1
AIR 2
HARDWARE 3
SOFTWARE 4
MAINTENANCE 5
ADV. MAINTENANCE 6
1
2
3
OrIENTaTION 1.1 QUICk STarT
WELCOME TO THE LUXE® EXPERIENCE. Follow these simple steps to get your new Luxe® marker up and
running in no time.
STEP ONE CHarGE THE BaTTErY (INCLUDED)
MAKE SURE THE LUXE®’S INTERNAL LITHIUM-POLYMER BATTERY is fully charged. Remove the rubber grip
from your Luxe® and connect the charger to the charging port on the front of the grip frame before plugging
the charger into a domestic electrical outlet. The L-shaped slot on the charger's SATA connector only fits
in one direction - make sure it is oriented correctly. The included charger will operate on either 110 or 240
volt standard AC power. The LED on the charger will glow solid red while charging, and solid green when the
battery is fully charged. Do not use the included USB/SATA atapter for charging. Reinstall the rubber grip.
STEP TWO aFFIX THE BarrEL BLOCkEr (INCLUDED)
ASSEMBLE THE LUXE® BARREL (see
HARDWARE 3.4) and screw it into your Luxe®. Slide the included barrel
blocker over the barrel and secure its cord as far back on the Luxe® body as possible, cinching it tight. The
barrel blocker is a critical piece of paintball safety equipment—nearly as important as paintball goggles.
The barrel blocker must be fully seated on the marker's muzzle and secured in place with its strap any time
the marker is stored or handled in an area where people are not properly protected by paintball goggles or
paintball field netting.
STEP THrEE FILL & INSTaLL YOUr aIr TaNk (SOLD SEParaTELY)
YOUR LUXE® IS DESIGNED TO OPERATE PROPERLY with high pressure compressed air (HPA—also commonly
referred to in paintball as nitrogen or nitro) as its power source. Mount your air system and have it filled, following
its manufacturer’s directions. If using a screw-in style compressed air system, first turn the Luxe® bottom-line
control knob counterclockwise one and a half turns, then screw the air system into the back of the ASA.

Related product manuals