EasyManua.ls Logo

DLX LUXE - Page 6

DLX LUXE
36 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
LUXEPaINTBaLL.COm
866.573.LUXE(5893)
5
6
7
STEP FOUr INSTaLL YOUr LOaDEr (SOLD SEParaTELY)
THE ANTI-CHOP VISION SYSTEM IN YOUR LUXE® will allow it to work with any loader. Best performance
and highest rate of fire however, will only be possible with a high performance force-feed loader system. Open
the marker's locking feedneck by pulling the lock lever away from the neck, then insert the loader and secure
it in place by folding the lever back to its locked position. Loader necks vary in size from brand to brand. If
the loader does not fit securely or the lock lever does not easily close, see Orientation 1.3 in this manual for
feedneck clamp adjustment instructions.
STEP FIVE TUrN ON aIr
GENTLY GAS UP YOUR LUXE® BY SLOWLY TURNING the air system on or by turning the Luxe® bottom-line
control knob clockwise.
A GENTLE RISE IN PRESSURE IS IMPORTANT, AS A SUDDEN BLAST MAY REDUCE THE SERVICE LIFE OF PRESSURE
SEALS WITHIN YOUR LUXE®.
The Luxe® bottom-line control knob must be turned off (counterclockwise) before removing screw-in
compressed air systems.
STEP SIX POWEr ON YOUr LUXE® markEr
TURN THE MARKER ON BY DOUBLE-CLICKING (quickly pressing twice) the power button, or by holding it
down for two seconds. Turn it off by pressing and holding the power button for two seconds. When the Luxe®
turns on, the OLED display will be activated, indicating the marker's status.
ALTHOUGH THE POWER BUTTON SERVES AS THE LUXE®’S SAFETY SWITCH TO PREVENT ACCIDENTAL FIRING, IT
SHOULD NEVER BE RELIED UPON IN PLACE OF A BARREL BLOCKER AND PROPER PAINTBALL EYE PROTECTION.
STEP SEVEN aDJUST LUXE® VELOCITY
FILL THE HOPPER WITH PAINTBALLS and turn it on. While wearing ASTM compliant paintball goggles, in an
area where all bystanders are protected, remove the barrel blocker and fire over a chronograph to measure the
velocity. Using a 5/32-inch allen wrench on the adjuster in the bottom of the vertical regulator, turn clockwise
to increase velocity/pressure, and counterclockwise to decrease. Take three or four shots after every adjustment
to allow the gas pressure inside your Luxe® to stabilize. Adjust until the marker is firing consistently within the
limits for the field where you are playing.
NEVER ADJUST YOUR LUXE TO FIRE AT GREATER THAN 300 FEET PER SECOND.
4
PaGE 7
1.1 QUICk STarT

Related product manuals