Digital Monitoring Products, Inc. | XTLtouch System User Guide 11
WHEN THERE’S AN ALARM
When the alarm bell or siren is sounding,
enter your user code or present your keyfob
to your keypad. IS THIS A FALSE ALARM?
YES NO displays.
• REAL ALARM
If the alarm is valid, press NO to
confirm the alarm and notify the
Emergency Monitoring Station that
a real alarm is happening. Your
security system remains armed.
• FALSE ALARM
If it’s a false alarm, press YES to
cancel the alarm and send an
abort message to the Emergency
Monitoring Station. Your security
system disarms.
WHEN YOU’RE AT HOME
1. On the home screen, press and
release the shield icon.
2. The screen displays ENTER CODE.
Enter your user code or present a
keyfob to disarm the system.
3. You should see ALL SYSTEM OFF
displayed in the upper right corner
after the system disarms. The shield
outline indicates a disarmed status.
WHEN YOU’RE ENTERING
THROUGH AN ARMED DOOR
1. When you open an armed door, the
prewarn tone sounds and the keypad
displays ENTER CODE. Enter your
user code or present a proximity
card or keyfob to disarm the system.
Only those areas authorized for your
user code will disarm.
2. Your system silences the tone as
soon as the first user code digit
is pressed. If a valid user code is
not entered within 5 seconds or
an invalid user code is entered, the
prewarn tone begins sounding again.
3. You should see ALL SYSTEM OFF
displayed in the upper right corner
after the system disarms. The shield
outline indicates a disarmed status.
To Next Page
Loading...
Need help?
General
