DMP Electronics XTLtouch - Z-Wave Device Management; Adding Z-Wave Devices; Viewing Z-Wave Devices; Removing Z-Wave Devices

Digital Monitoring Products, Inc. | XTLtouch System User Guide 23
ADDING A Z-WAVE DEVICE
1. Access the user menu and press
CMD until ZWAVE SETUP? appears,
and then press any select area.
2. Press ADD.
3. Press the Z-Wave button on the
device you are adding and wait for
your keypad to recognize it.
VIEWING A Z-WAVE DEVICE
1. Access the user menu and press
CMD until ZWAVE SETUP? appears,
and then press any select area.
2. Press LIST.
3. All of the Z-Wave devices that
are connected to your system will
display on the screen. Press CMD
to cycle through your devices, if
needed.
REMOVING A Z-WAVE DEVICE
1. Access the user menu and press
CMD until ZWAVE SETUP? appears,
and then press any select area.
2. Press REMOVE.
3. Press the Z-Wave button on the
device you are removing. Wait for
your keypad to display that the
device has been removed.