14 DNP IMS America Corp.
Properties Software Update Procedure
Advanced Printing Features
Always have this set to Enabled. DO NOT change it to other settings.
Border
This settings is synchronous with the border option in the Paper tab.
Overcoat Finish
The overcoat finish for the printed surface can be selected from the following two types:
Depending on the version being used, “Glossy” may be the only available option.
Print Re-try
If printer errors, the setting in Print Re-try will determine if data in the printer buffer will print after error recovery.
According to the contents of a printer error, the power supply of the printer may need to be re-switched on for error
recovery. In this case, it is not dependant on the setup of Print Re-try, and printing data in a printer buffer is cleared.
2inch cut
In the case of a specific paper size of DS40, it sets up whether the printer cuts into two or more sheets in 2” length.
Overcoat Finish Function
Glossy This finishes the print with a glossy surface.
Matte This finishes the print with a matte (non-glossy) surface.
Print Re-try Function
Disable Printing data in the buffer is cleared after printer error.
After an error recovery, the cleared image data must be resent.
Enable Printing data in the buffer is held after printer error.
After an error recovery, the print process resumes with the saved data in the buffer.
However, if printer is powered OFF, it is lost.
2inch cut Function
Disable It cuts in usual size
Enable If set to 4x6 size, the printer will cut the print into two 2” sheets.
If set to 6x8 size, the printer will cut the print into four 2” sheets.
To Next Page
Loading...
