16
deactivates SPM, the remote beeps twice, and the “stat” LED will stop blinking
white .
o Throttle+
Pressing the “sel” button together with an engine button, will engage that engine or
motor in Throttle+. Pressing an engine button alone, will engage that engine or motor
in minimum/idle speed. More about Throttle+ in the Engine buttons part of this section
of the manual
• Anchor winch buttons
By pressing the upper button, you lower the anchor.
By pressing the lower button, you raise the anchor.
This behaviour can be switched in the Dockmate Settings, during the installation or sea trial.
These buttons only operate an anchor winch if installed on the boat and your Dockmate
Receiver is configured for it. Otherwise, this has no effect. When pressed together, you can
choose between windlass 1 and 2 (2 or 4 beeps), if the Dockmate Receiver is fitted with a twin
anchor winch module.
• link: Radio Status LED
Shows the status of the connection with the Receiver
It also shows warnings and errors if there are any.
To Next Page
Loading...
