17
• stat: Battery Status LED
Shows the battery status of the remote on start-up and when the battery charge gets low. It
also shows if any special options have been activated through Dockmate. While charging
your TWIN or SINGLE, this LED will blink to indicate it is charging and how full the battery is.
• Buzzer & vibrator
Indicates no communication, low battery, warning, or error.
• Bow thruster buttons
By pressing the left button (red = port), the bow thruster will push the bow to port.
By pressing the right button (green = starboard), the bow thruster will push the bow to
starboard.
These buttons only operate a bow thruster if installed on the boat and your Dockmate
Receiver is configured for it. Otherwise, this has no effect.
When your thruster(s) are proportional and the Dockmate Receiver is configured with a
CAN bus thruster module (Vetus V-CAN, Sleipner S-Link, ABT-TRAC Link, or CMC-
CANopen), the maximum output of your thrusters can be configured during the
Dockmate installation or sea trial.
To Next Page
Loading...
