DOLD DMP 96 A - Lower 7-Segment Display; Leds; Explanations of Symbols

DOLD GMBH Operating instructions DMP 96 A
DMP 96 A Version: 020 Number of pages: 26
H0e020bA4.doc Edition: 07.11.2006
12
5.2 Lower 7-segment display
shows:
• setpoint
• parameter value in entry mode
• alternation between " -y- " / manipulated variable when actuator function is activated (man-
ual function)
• alternation between setpoint (auxiliary setpoint) / "Opt" during the self-optimization proce-
dure.
5.3 LED's:
LED: K 1 yellow lights up when output K 1 is active
LED: K 2 yellow lights up when output K 2 is active
LED: 1 green lights up when continuous-action controller is functioning
LED: 2 green lights up when logic input is activated (contact closed)
6. Explanations of symbols:
Display: Meaning:
"P.nr" Current program number
"SP.1" Setpoint 1
"SP.2" Setpoint 2
" -y- " Manipulated actuator value
"Cod" Code entry
"Con" Enter configuration level
"Cor" Line compensation or zero-point offset
"rA.H" Set upper limit of setpoint range
"rA.L" Set lower limit of setpoint range
"Co.1" Configuration, relay contact K 1
"Co.2" Configuration, relay contact K 2
"Fd.1" fault on control output K 1
"Fd.2" fault on control output K 2
"rES" Display resolution
"Aut" Configuration of automatic function
"Co.u" Configuration of setpoint setting
"Co.A" Configuration of analog input
"An.H" Setting of upper measuring range limit for actual-value output
"An.L" Setting of lower measuring range limit for actual-value output
"Co.L" Configuration of logic input
"3-P" Configuration of three-point response
"uSr" Enter setpoint entry level
"PAr" Enter parameterization level
"Pb.1" Proportional band, control contact K 1
"ti.1" Reset time, control contact K 1
"td.1" Derivative action time, control contact K 1
"CY.1" Cycle time, control contact K 1
"HY.1" Switching hysteresis, control contact K 1
"bd.1" Symmetrical. spreading, limit comparator K 1
"LA.2" Absolute setpoint value, limit-value contact K 2
"Lr.2" Relative setpoint value, limit-value contact K 2
"bd.2" Symmetrical. spreading, limit comparator K 2
"HY.2" Switching hysteresis, limit-value contact K 2