DOLD DMP 96 A - Connecting the Controller; Auxiliary Power; Terminal Connection Diagram; Mechanical Data

DOLD GMBH Operating instructions DMP 96 A
DMP 96 A Version: 020 Number of pages: 26
H0e020bA4.doc Edition: 07.11.2006
6
1.3 Connecting the controller:
1.3.1 Auxiliary power:
Auxiliary power (operating voltage) as per identification plate:
Standard: 230 V AC (±10%), 48...62 Hz,
Power consumption, depending on model: ≤ 6 VA,
Not affected by voltage fluctuations within the defined rangeTerminal connection diagram:
1.3.2 Terminal connection diagram:
This connection diagram shows maximum terminal assignment for the controller when all con-
nection possibilities are used. The appropriate terminal assignment (depending of the type of
controller used) can be found in the accompanying connection diagram.
Connection diagram number according to identification plate: ASP 675XXX
5
12
14
15
13
10
11
9
8
7
6
3
4
2
1
Operating voltage
-
+
U/I output
Logic input
thermometer,
Logic outputs (optional)
-
+
-
+
Relay outputs
K 2
K 1
Caution:
Terminal 2 (-) and
terminal 6 (-) do not
have the same
potential!
thermometer,
Thermal converter
-
+
3-wire leads
Resistance Resistance
2-wire leads
Figure 2: DMP 96 A connection diagram
1.4 Mechanical Data:
Protection class: VDE 0631
Insulation group: C as per DIN VDE 0110 b
Type of protection: As per DIN VDE 0470 (replaces DIN 40 050)
EN 60 529 / IEC 529
Front panel: IP 50 (optionally: IP 54 with the proper mounting
and a suitable sealing ring)
Housing: IP 30
IP 20