DOLD DMP 96 A - The Various Levels; Setting the Setpoint; Setting the Setpoint Via the Operator Level

To Next Page

To Previous Page

DOLD GMBH Operating instructions DMP 96 A

DMP 96 A Version: 020 Number of pages: 26

H0e020bA4.doc Edition: 07.11.2006

7.2 The various levels:

Press briefly

Operator level (only when function is released)

Code

100

Press for 3 s

Information level

(setpoint setting)

Self-optimization level

111

Code

Setpoint entry level (only when function is released)

Code

Parameter level

(setting of control parameters)

(starting and aborting of self-optimization)

(setpoint set by entering code)

(querying of current program number, sensor)

Code

155

Configuration level

(configuration of range limits,

control functions, etc.)

(only when function is released)

Figure 4: The various levels

7.3 Setting the setpoint:

How the setpoint is set depends on configuration (parameter ”Co.u” on the configuration level).

The setpoint can be set on the:

• operator level (factory configuration)

• setpoint entry level (setting made by entering a code number).

7.3.1 Setting the setpoint via the operator level:

Press key briefly to jump to the operator level

Display: Parameter: Range: Factory

setting:

"SP.1" Setpoint 1 "rA.L...rA.H"

0.0°C