DOLD DMP 96 A - Page 3

To Next Page

To Previous Page

DOLD GMBH Operating instructions DMP 96 A

DMP 96 A Version: 020 Number of pages: 26

H0e020bA4.doc Edition: 07.11.2006

7. OPERATION:........................................................................................................13

7.1 Setting parameters on the various levels: ...................................................................................13

7.2 The various levels: ......................................................................................................................14

7.3 Setting the setpoint:.....................................................................................................................14

7.3.1 Setting the setpoint via the operator level: ...............................................................................14

7.3.2 Setting the setpoint level via the setpoint entry level:...............................................................15

7.4 The configuration level: ...............................................................................................................15

7.4.1 Switching response of the K 2 limit-value contact:...................................................................19

7.5 The parameterization level:.........................................................................................................19

7.6 The self-optimization level:..........................................................................................................20

7.6.1 Monitoring the optimization process:........................................................................................22

7.7 The information level:..................................................................................................................23

8. LINE COMPENSATION, ZERO-POINT OFFSET:................................................24

8.1 Line compensation: .....................................................................................................................24

8.2 Zero-point offset: .........................................................................................................................24

9. ERROR MESSAGES:...........................................................................................25

9.1 Error messages (display): ...........................................................................................................25

10. PROGRAM VERSION: .......................................................................................25

11. IMMUNITY: .........................................................................................................26