Dolmar CS-246.4C - User Manual

Questions and Answers

J
joshua10Aug 1, 2025
What to do if my Dolmar Lawn and Garden Equipment engine stops soon after starting?
- D
  Debbie ChenAug 1, 2025
  If your Dolmar Lawn and Garden Equipment engine stops shortly after starting, it might be due to insufficient warm-up; perform a warm-up operation. Another cause could be that the choke lever is set to “CLOSE” even though the engine is warmed up, so ensure it is set to “OPEN”. Also, check for a clogged fuel filter and clean or replace it if necessary. A contaminated or clogged air cleaner could also be the issue, so clean it.
J
james17Aug 6, 2025
What to do if my Dolmar CS-246.4C Lawn and Garden Equipment attachment does not stop immediately?
- B
  bradley81Aug 6, 2025
  If the attachment on your Dolmar Lawn and Garden Equipment doesn't stop immediately, it could be due to high idling rotation, which needs adjustment, or a detached throttle wire, which needs to be securely attached.
A
Alexander VangAug 11, 2025
What to do if my Dolmar CS-246.4C main unit vibrates abnormally?
- F
  Frank WareAug 11, 2025
  If your Dolmar Lawn and Garden Equipment's main unit is vibrating abnormally, ensure the attachment is inserted to the specified point as instructed. Also, check for any loosened levers and tighten them securely.
M
meyerswilliamAug 16, 2025
What to do if my Dolmar CS-246.4C attachment does not rotate or move?
- J
  Jacob ScottAug 16, 2025
  If the attachment on your Dolmar Lawn and Garden Equipment is not rotating or moving, make sure that the attachment is inserted to the specified point as instructed.
S
Stacy ThomasAug 21, 2025
What to do if my Dolmar CS-246.4C engine does not stop?
- R
  rosekathleenAug 21, 2025
  If your Dolmar Lawn and Garden Equipment engine won't stop, check for a detached connector and attach it securely.
P
Peter CarrollOct 26, 2025
Why won't my Dolmar Lawn and Garden Equipment engine start?
- D
  David BarrettOct 26, 2025
  There are several reasons why your Dolmar Lawn and Garden Equipment engine might not be starting. It could be due to a failure to operate the primer pump; try pushing it 7 to 10 times. Other potential causes include low pulling speed of the starter rope, so pull strongly. Also, check for a lack of fuel and replenish if needed, or a clogged fuel filter, which you should clean. A broken or deteriorated fuel tube, which you should straighten, or deteriorated fuel, which should be replaced (recommended every month), could also be the cause. Other possible solutions are to attach a detached plug cap securely or clean a contaminated spark plug. If there is excessive suction of fuel, set the throttle lever from medium speed to high speed, and pull the starter handle until the engine starts. Once ...